Danfoss SET 3E Instrukcja Użytkownika Pobierz pdf (Strona 5)

use in a system having GRAVITY primaries, remove

the small link located on the rear of the unit. The link,

which is clearly labelled can be found on the bottom

RIGHT hand side of the unit.

7. Ensure all dust and debris are cleared from the area.

8. Locate the module on the latches at the bottom of

the wallplate and hinge upwards to fully engage the

unit connectors into the wallplate. Tighten the two

ﬁ xing screws to secure the unit to the wallplate.

9. Before setting the programme, check the unit and circuit.

Switch ON the mains supply and press both WATER

& HEATING rocker switches to the ON position - both

red LED’s should now be illuminated. Adjust any remote

thermostat to check the services operate correctly.

10. Then press both WATER and HEATING rocker

switches to the OFF position and check that both

services do not operate.

11. Finally, press both WATER and HEATING rocker

switches to TIMED position prior to programming the unit.

Installation

1 2 3 4 5 6 7 8 9 10 ... 19 20

Brak uwag

Danfoss SET 3E Instrukcja Użytkownika Strona 5