Danfoss TP5000 si range Instrukcja Obsługi Pobierz pdf (Strona 11)

Installation Instructions

Option 36 - Set temperature override rule

This establishes the degree of temperature override

available to the user. Press + until Option 36 is

displayed, use

V and Λ to select required setting.

Setting 0 No limit (factory setting)

Setting 1 Limited to ±2°C

Setting 2 No override allowed

Option 37 - Set time duration of override rule

(Option 36 set to 1 or 2)

This establishes the duration of a temperature

override available to the user. Press + until Option 37

is displayed, use V and Λ to select required setting.

Setting 0 Next event (factory setting)

Setting 1 1 hour

Setting 2 2 hours

Setting 3 3 hours

Setting 4 4 hours

Option 38 - Relay state on low battery detect

(battery products only)

This establishes the position that the relay is driven to

when the unit shuts down due to low battery state.

Press + until Option 38 is displayed, use

V and Λ to

select required setting.

Setting 0 Relay parked with output OFF (factory setting)

Setting 1 Relay parked with output ON

Option 40 - Number of Events per Day

This sets the thermostat to operate with either 2, 4 or

6 switching events per day or to run it in stat mode.

Press + until option 40 is displayed, use Λ or V to

select required setting.

1 Stat mode

2 Two switching events per day

4 Four switching events per day (Factory setting)

6 Six switching events per day

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Brak uwag

Danfoss TP5000 si range Instrukcja Obsługi Strona 11