Danfoss TripleLynx CN Instrukcja Instalacji Pobierz pdf (Strona 213)

Solar-Log1000: Configuration at the unit

Changing the network settings (Basic/Network)

Solar-Log

1000/500/200

Installation 213 of 268

If no inverters have been detected, this is also indicated on the display. In this

case, the detection process must be repeated.

Once detection has been completed successfully, you are asked whether in-

verter configuration ( Page 223) is to be carried out.

If all inverters have been detected.

 Confirm with by selecting Yes

 The “Configure inverter data” dialogue box opens ( Page 223).

10.5 Changing the network settings (Basic/Network)

Configuring the network settings – if this is necessary after the initial configu-

ration – covers the following points:

 Changing the network access

 Changing the DHCP settings

 Analogue modem settings

 Settings for GPRS modem

 Solar-Log

1000

WiFi: WLAN configuration (Basic/WLAN)

To configure the basic network settings:

 In the menu, select Config./Basic Network

10.5.1 Changing the network access

Here, the IP address and Subnet mask of the Solar-Log

1000

can be configured

if necessary.

However, all routers with the DHCP service enabled are preset so that this da-

ta is entered automatically:

Dialogue boxes

 IP Address, Subnet Mask

The factory setting of the address is 192.168.178.49, and can be adapted

only through a direct PC connection, or through a router without the DHCP

service, in order to allow access from a PC.

In this case, please consult a network specialist who can assign a suitable

network address, make the other gateway settings and so on.

1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 267 268

Brak uwag

Danfoss TripleLynx CN Instrukcja Instalacji Strona 213