Danfoss TripleLynx CN Instrukcja Instalacji Pobierz pdf (Strona 96)

Connecting the inverters

Sungrow

96 of 268 Solar-Log

1000/500/200

Installation

Procedure

1 If you are fabricating the cable yourself, connect the wires as shown in the

following diagram:

Solar-Log™ terminal block connector

Inverter round socket

Terminal

 1

 1 (A)

 4

 2 (B)

2 Insert round plug into socket B on the inverter.

3 If only one inverter is to be connected terminate this in accordance with the

inverter instructions.

4 Insert the terminal block connector into the Solar-Log™ RS485 socket.

Connecting the inverters to each other (Solar-Log

500

, Solar-Log

1000

)

 Connect using the RS485 cable (supplied with the inverter).

 Where to connect: COM round sockets on the outside of the inverter.

Procedure

1 Insert the round plug into the COM A socket on inverter 1.

2 Insert the other end of the wire into the COM A socket on inverter 2.

3 Insert the round plug into the COM B socket on inverter 2.

4 Connect the other inverters to each other using COM A and B sockets.

5 Terminate in the last inverter in accordance with the inverter instructions.

Allocating communication address

 Recommendation: Continuous numbering starting with 1.

 Setting: Using the inverter operating display

 Procedure: As set out in the inverter's instructions

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 267 268

Brak uwag

Danfoss TripleLynx CN Instrukcja Instalacji Strona 96